Page 99 - 《橡塑技术与装备》英文版2026年2期

EQUIPMENT MANAGEMENT AND MAINTENANCE

etc. Third, the inspection of rotating parts, such as T-shaped weighing systems. Eighth, the inspection of the operating status
screws, ball screws, shaft sleeves, and other relative rotating of automatic control systems. Ninth, the inspection of loads
parts. Fourth, the inspection of relative sliding parts, such as such as voltage, current, pressure, temperature, and flow during
linear guides, guide rods and guides, sliding surfaces, etc. equipment operation. Tenth, the inspection requirements for
Fifth, the inspection of the lubrication and oil supply status the operating status of supporting special equipment and other
of air source processing components. Sixth, the inspection of process production equipment should be carried out according
sliding bearings, rolling bearings, hinge points, and other parts to their operating procedures. Eleventh, other operating status
of various locations. Seventh, the lubrication status inspection inspection requirements that need to be proposed.
requirements for supporting special equipment and other
process production equipment should be carried out according 7 Common faults and troubleshooting
to their operating procedures. Eighth, other lubrication status methods
inspection requirements that need to be proposed. This content typically includes fault symptoms, causes,
The status inspection of the automatic equipment and solutions. The table format can be adjusted according
lubrication system typically includes checking the integrity to the equipment structure and management needs. The
and condition of the lubrication device; ensuring that the oil commonly used format is shown in table 3.
quality meets the equipment requirements and the oil quantity Table 3 Common faults and troubleshooting methods
is adequate without excess or deficiency, thereby guaranteeing Fault phenomenon Cause of failure Treatment method
lubrication efficiency; verifying that the oil circuit is unblocked,
free from leaks, and flows smoothly to all lubrication points; 8 Supplementary provisions
confirming that the oil temperature and pressure are within The supplementary provisions typically outline the
normal ranges, without overheating or overcooling; and departments responsible for the compilation, revision,
verifying that the lubricating oil cooling device is functioning
interpretation, and management of procedures; require joint
properly, ensuring that the temperature of the lubricating oil is review by units and departments related to the procedures,
controlled within an appropriate range. which must be approved by the company leaders in charge of
6.2 Equipment operation status inspection the equipment; and finally specify the implementation date and
It is necessary to specify the parts, contents, standards, inform of the cancellation of previous similar procedures.
and methods that production employees need to inspect for
various devices and mechanisms of equipment under operating 9 Conclusion
conditions, in order to prevent malfunctions or accidents. The article "Method for Preparing Equipment Operation
The inspection parts of equipment operating conditions Procedures" combines modern equipment management concepts
mainly include, but are not limited to, the following aspects. and summarizes the methods, content composition, and
First, the inspection of the connection and fastening, as well preparation requirements for equipment operation procedures.
as the intactness, of the equipment foundation and body It serves as a guiding document for the preparation of various
structure. Second, the inspection of the supply status of the types of equipment operation procedures. The two parts of
power medium system. Third, the inspection of the working the article, namely "Equipment Lubrication Regulations" and
conditions of equipment driving, transmission, braking, and
"Common Faults and Troubleshooting Methods," should be
speed change. Fourth, the inspection of the operating status reflected in equipment maintenance and repair procedures.
of the automatic lubrication system. Fifth, the inspection of This article is included to enable operators to directly conduct
electromechanical safety protection and warning devices. equipment lubrication status checks, fault analysis, judgment, and
Sixth, the inspection of the operating status of power supply troubleshooting based on the standards. Given the author's level,
and distribution equipment and facilities. Seventh, the it is inevitable that there may be some shortcomings. Readers are
inspection of equipment detection devices, metering, and welcome to provide criticism and corrections.

Vol.52，2026 ·55·